Settings; Changing Settings; Reach - Goobay 71364 Mode D'emploi

User manual
7

Settings

Fig. 10: Settings
7.1

Changing settings

1. Adjust the switch-off delay TIME by using a screwdriver between 10
seconds and 12 minutes.
2. Adjust the preferred brightness sensivity LUX by using a screwdriver.
The lighting intensity in LUX is the response limit, the motion detector triggers
below. If this trigger only should work at night, it must be set to 3 LUX. If the
motion sensor should trigger at night and day, set it to the sun symbol
The trigger sensitivity settings for twilight, etc. are indeed after installation
and must be tested depending on demand.
3. Set the reach SENS a between 2-6 m.
7.2

Reach

Tab. 4: Reach
17
120°
.
360°