SOLIS CITRUS PRESS STATION 8454 Mode D'emploi page 73

▲
TROUBLESHOOTING
Problem
The appliance
does not function.
Motor overload
protection has been
triggered.
Solution
– Was the power plug connected to a working power
outlet?
– Was the ON/OFF switch set to the position I ?
– Was the juicing cone pressed down?
– Were juicing cone and pressing cone correctly
mounted to the appliance?
– Were pulp filter and juice collection tray correctly
installed?
– The motor overload protection has been triggered.
(See below for details)
– To protect the motor, your Solis Citrus Press Station
is fitted with overload protection. Should the juicer
suddenly stop after prolonged use or when processing
fruits that are hard to juice, pull the plug and let the
appliance cool down for 15 minutes. Once the appli-
ance has cooled down, you can start using it again.
– Note: To reset the motor overloading protection, it is
vital that the appliance is switched off and the power
plug is disconnect! Wait for 10 minutes before recon-
necting the appliance to the power mains, switching it
on and starting to use it again.
– In spite of the newly fitted motor overload protec-
tion, we recommend not juicing too many fruits in
one go but instead always processing them in smaller
amounts. Always take a 10 minute break after having
the appliance in use for 10 minutes!
GB
73