▲
OPERATION
1. Check if the Solis Citrus Press Station has been assembled correctly in the
described way.
2. Cut the citrus fruit in two halves. To squeeze juice more effectively, you should
cut the fruit laterally, not lengthwise from end to end.
Note: Some citrus fruits, e.g. mandarines, might have thicker ends. To ensure
optimal contact to the juicing cone, it is recommended to clip the pointed ends
with a knife.
GB
3. Plug the power plug into a suitable wall outlet. Switch the appliance on with
the ON/OFF switch (position I), the orange function light in the switch lights up.
Now, place a glass or another container under the juice spout.
4. Place one half of the citrus fruit, with the cut side facing down, on the juicing
cone and press the fruit onto the spike of the juicing cone.
Caution: If you apply too much pressure, you engage the automatic activation
and the juicing cone starts rotating!
Take the lever handle of the press arm and push the lever press arm down slowly
in one smooth movement, until the squeezing cone comes into contact with the
fruit skin. Once this contact is made and some pressure is applied, the motor will
start automatically and the juicing cone will begin spinning. The juice is squeezed
from the fruit and runs through the juice spout into the glass resp. the container.
The pulp and the pips are collected in the pulp filter.
Caution: If the juicing cone does not spin, it might be because the pulp sieve is
not correctly placed in the juice collection tray, preventing the juicing cone from
sliding all the way down. Please refer to section 5 on page 67.
5. As the Solis Citrus Press Station works very effectively, it will only take a few
seconds until one fruit half is juiced. After a short time, you can return the lever
press arm into the highest position and the motor will stop automatically.
6. Take the squeezed-out fruit half from the juicing cone and, if necessary, empty
out the pulp filter resp. repeat steps 4 to 6 to juice the other fruit halves.
Caution:
Do not apply too high pressure to the press arm, the pressure should not exceed
●
3 kg. Press for a maximum of 15 seconds and then stop applying pressure for
15 seconds.
If the appliance has been in use for 10 minutes, you should take a break of
●
10 minutes in any case.
68