Télécharger Imprimer la page

Kärcher BDS 43/Orbital C Spray Mode D'emploi page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
Installation
Mounting the push rod
1. Align the holes in the push rod with the
holes in the device.
Illustration B
Device
1
Screw
2
Thrust rod
3
Cable
4
2. Screw in and tighten the 4 screws.
3. Insert the plug into the coupling.
Illustration C
Casing half
1
Plug
2
Socket
3
4. Insert the two halves of the housing into
one another so that the connection is
protected against spray water.
Attaching the cable hook
A cable hook is attached to the push rod at
the top and bottom.
1. Hold both halves of the cable hook
against the push rod.
Illustration D
Cable hooks
1
Thrust rod
2
2. Push both halves into each other in the
direction of the arrow.
3. Insert the screw through the cable hook.
Illustration E
Star grip
1
Screw
2
4. Unscrew the star grip.
5. Push the cable hook all the way down
and align it on the push rod
6. Tighten the star grip.
7. Attach the second cable hook to the top
of the push rod in the same way.
Attaching the detergent tank
1. Release the star grip on the upper cable
hook.
2. Screw the chain to the detergent tank.
Illustration F
Chain
1
Detergent tank
2
3. Attach the hose to the hose nipple at the
bottom of the detergent tank.
Illustration G
Hose
1
Hose nipple
2
Note
The lower cable hook must be attached as
low as possible, otherwise the dosage of
the cleaning solution will not work correctly.
4. Slide the detergent tank onto the lower
cable hook.
Illustration H
Detergent tank
1
Lower cable hook
2
5. Push the upper cable hook down to the
detergent tank. Make sure that the pin
on the tank sits in the recess on the ca-
ble hook.
Illustration I
Detergent tank
1
Pin
2
Star grip
3
Recess
4
6. Tighten the star grip on the upper cable
hook.
7. Fit the hose to the hose nipple on the de-
vice.
Illustration J
Hose nipple
1
Hose
2
8. Guide the chain through the opening on
the handle and on the detergent dosing
lever.
Illustration K
Detergent dosing lever
1
Chain
2
Connecting the spray system
Only the BDS 43 / Orbital C Spray is
equipped with a spray system.
1. Fit the hose from the detergent tank onto
the pump inlet.
Illustration L
Hose
1
Pump inlet
2
Pump
3
English
13

Publicité

loading

Ce manuel est également adapté pour:

Bds 43/orbital c