Substituting A Deteriorated Blade; Solutions To Most Frequent Anomalies - Sima AMBAR 200 Manuel D'utilisation Original

Always follow the safety recommendations mentioned in this manual.
It is not allow any modification in any of the parts, elements or features of the machine. SIMA SA is not
responsible for any consequences that may result from failure to follow these recommendations.

11.1 SUBSTITUTING A DETERIORATED BLADE

The cutting blade is one of the most important elements of a cutting table. A blade in good condition is
essential to get an optimal performance of the machine. Replace it when worn-out, twisted or cracked.
Do not use any kind of blade that is not specified in this manual and make sure the blade has the required
characteristics of the maximum diameter, central drill diameter and the maximum number of revolutions supported.
Bear in mind that within the group of diamond blades, there are different types depending on the material to
cut. Choose always the most appropriate to your case.
As mentioned before, we recommend you to use always SIMA ORIGINAL DISCS that meet the technical and
safety requirements and are offered in a wide range that covers all the needs and facilitates the right choice.

12. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Motor does not
start up
Motor starts up
very slowly and
Damaged condenser. (Single phase
takes long to
reach its
revolutions
Bluntness of the blade segments or
Cutting power
insufficient
The cooling water
does not reach
the blade
The pump water tape is closed
blade premature
damage
POSSIBLE CAUSE
Power supply fault
Damaged switch
Blocked blade
motors)
diamond bands
Inappropriate blade
Motor low potency
Water level low in the tray
Pump blocked
Pump damaged
Insufficient cooling
Excessive advance
Inappropriate blade
SOLUTION
Check the power supply in the switch
board. Check the position of the thermal
magnet and the differential in the switch
board. Make sure the extension cable is in
a good state and well plugged in both
ends
Substitute it
Remove obstacles preventing the blade
from turning
Substitute it
Effectuate different cuts on an abrasive
material (Sandstone, concrete, stone
emery)
Use appropriate blade for material
Let the motor be checked by technical
service
Fill in water to level
Dismount the tape filter and clean it
Substitute the pump
Open the water tape
Check the cooling
Decrease the advance
Use appropriate blade for material
-11-
ENGLISH