Filling The Water Tray; Electrical Connection; Qualified Electrician; Machine Components (Fig.1) - Sima AMBAR 200 Manuel D'utilisation Original

3.1 FILLING THE WATER TRAY

The AMBAR 200 models are designed to work with diamond blades cooled by water. Therefore, an important
part of the frame is a tray intended to serve as the cooling water deposit pumped in a closed circuit to blade.
ATENCION: Before plugging the machine to the electricity to effectuate any cutting operation, the water tray
should be filled until the pump has been completely covered.
During cutting operations, a large amount of dirt is accumulated in the tray. Thus, you have to change the
water as often as necessary to ensure the smooth functioning of the pump and the perfect cooling of the blade. The
tray has a stopper to remove once you want to change the water.

4. ELECTRICAL CONNECTION

Upon receipt of the machine, make sure the network electrical tension is adequate before plugging the machine. The
electrical tension is to be found on the voltage indication next to the switch of the machine.
WARNING: Never plug the machine to electricity, in case the network power tension is not the adequate
as the engine would undergo irreparable damages
WARNING: Never manipulate power supply cables or any other electrical equipment on the machine
before you unplug the machine from electricity
Only when you have accomplished all the before mentioned safety measures, the cutting blade can be
mounted on the machine.
The wires of this product are colored (see Fig.4)
Blue
Brown
Green and Yellow
When the colors may not match the colored markings identifying the terminals in your plug, proceed as follows.
• The blue wire must be connected to the terminal marked with the letter N or black colored, brown wire must be
connected to the terminal which is marked L or red colored.
• This device must be protected by a suitable fuse.
• Use a residual current device (RCD) will reduce the risk of electrical shock
.
Never connect the brown or the blue wire to wire grounding plug, 13 amp. IN CASE OF DOUBT CONSULT A

QUALIFIED ELECTRICIAN

5. MACHINE COMPONENTS (FIG.1)

1.-switch on / off
2.-Slip handle for cutting head
3.-Transport fastening
4.-Blade
5.-Tray
6.-Legs
7.-Graduable rule
8.-Workbench
9.-Graduable square
10.-Graduation
12.-Water Pump
Neutral (N)
Electric Current (L)
Earth (E)
-7-
ENGLISH