Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. MACHINE ASEMBLING
Follow the steps in the same order when assembling the machine (see Fig.2).
Mount the four legs into position Fig.2, (6 and 5).
Place the machine on the water tray (Fig. 2, 14)
7. MOUNTING AND DISMOUNTING THE CUTTING BLADE
The AMBAR 200 models are designed to use segmented diamond blades or with a continuous rim with 200mm
diameters depending on the model.
The cutting blades have different properties depending on the material to cut. Hence, an adequate selection
of the blade increases the performance and guarantees a better result.
Make sure the maximal supported revolutions by the blade are equal or superior to those of the machine's
engine.
7.1 MOUNTING PROCEDURE AND REPLACEMENT OF A CUTTING BLADE
The blade can be mounted or replaced as follows (Fig.3):
•
Make sure the power supply cable of the machine is disconnected.
•
Remove the blade safeguard (Fig.3, 15) of the cutting bridge of the machine loosening the screws that fix it.
•
Block the rotation of the axis inserting a key in the back part of the motor.
•
Loosen the axis nut (Fig.3, 16) with the hexagonal key, and remove the outer bridle (Fig.3, 17).
•
WARNING: The nuts are left-threaded
•
Place the blade (Fig.3, 18) on its axis ensuring it is well centralised and perfectly located.
•
Place the exterior bridle(Fig.3, 17) back and tighten the axis nut (Fig.3, 16) using the set of keys used before.
•
Check the coupling (Fig.3, 18) between the blade and the bridles (Fig.3, 17) y (Fig.3, 19) before tightening the
nut.
•
Place the safeguard back (Fig.3, 15) in its position and tighten well the screws fixing the cutting head.
•
To dismount the blade, proceed in the inverse sense
WARNING: Remove all the used tools, making sure that all the elements of the machines have been
mounted in the correct position
• You can plug the machine to the electricity.
8. ELECTRICAL EQUIPMENT
The electrical equipment of the AMBAR 200 cutting tables manufactured by SIMA, S.A. has an IP54 protection
degree.
9. SAFETY RECOMMENDATIONS
The table saw AMBAR 200 model, should be used by persons who are familiar with its operation.
•
Before starting up the machine please read the instructions and make sure safety norms are
respected. Learn how to stop the machine in a fast and safe way.
-8-
ENGLISH
Publicité
Table des Matières
