General Information; General Description Of The Machine - Sima AMBAR 200 Manuel D'utilisation Original

1. GENERAL INFORMATION

WARNING: Pease read and understand perfectly the present instruction before using the machine.
SIMA S.A. thanks you for your trust in our products and for purchasing the TABLE SAW model AMBAR 200.
This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of
the present machine. All aspects as far as the safety and health of the users is concerned have been stated.
Respecting all instructions and recommendations assures safety and low maintenance. As such, reading this manual
carefully is compulsory for any person responsible for the use, maintenance or repair of this machine.
As such, reading this manual carefully is compulsory for any person responsible for the use, maintenance or
repair of this machine.
It is recommended to have always this manual in an easily accessible place where the machine is being
used.

2. GENERAL DESCRIPTION OF THE MACHINE

SIMA Mitring Cutting Table, AMBAR 200 model, are designed and manufactured to be used at masonry
building sites to cut stones and other construction materials, mineral and compounds with at least one bearing side
(tile, terrazzo, brick, marble, granite, concrete or ceramics shingle, stoneware... The cutting tool is a diamond blade
powered by an electric motor and water cooled by a closed-circuit pump. The progress of the blade is done manually
by moving the cutting head in the direction of the material to be cut. The PEARLA models are manufactured of high
quality materials.
Any use other than the machine has been designed for is considered inappropriate and can be dangerous;
therefore, it is expressly prohibited.
•
Materials cutting table AMBAR 200 is designed for a tiller who needs a very light and easy to move machine.
•
•
All AMBAR 200 cutting tables realise mitring cutting in ceramic materials for the construction: tile, sandstone, hardened
stoneware, porcelain...
•
The cutting head inclinable up to 45 degrees can make mitring cutting.
This machine carries out four basic functions that the tiller needs on work site.
1. Straight cutting
2. Mitring cutting (45º)
•
This machine has been designed and manufactured to cut with a water cooled diamond blade. The cooling is carried out by a
closed-circuit electric pump with a constant water flow.
•
The electric pump with a high impedance winding avoids its burning in normal conditions of use and certainly that it is always
covered with water.
•
As the motive group embodies an electric motor to move the cutting blade.
•
The group engine or cutting head slides through bearings across the bridge, entirely manufactured from reinforced aluminium.
•
The cutting bridge is enabled to receive an accessory where a drill can be mounted to make holes of various measures,
through diamond crowns.
•
The machine is protected with a screen that avoids the projection of water in the direction of the cut towards the back of the
machine.
•
The frame of the machine is painted with a highly resistant epoxy polyester paint that protects the frame from corrosion.
•
AMBAR 200 models have detachable legs to facilitate their transport.
-5-
ENGLISH