Magontec CORREX MP 2.3-900 Notice D'utilisation page 26

Operating Instructions CORREX
2. Important information concerning the use of the present
operating instructions
Read this information before reading the operating instructions.
2.1 Scope of application
The present fitting and operating instructions are applicable to the impressed
current anode system CORREX
in the Annex.
The manual covers the following mountings:
• Socket mounting
• with screw G
• with screw G 1"
• with screw G 1
• Insulated-hole mounting
• with M8 threaded bolt for 10.5 mm fitting bore
2.2 Anode types to be used
The impressed-current anode system CORREX
different types of anodes. Information about which type of anode is suited to
which type of hot-water storage tank can be obtained from the storage tank
manufacturers who will also provide information on the length and the number
of anodes that can be installed in the storage tank. This is particularly impor-
tant if older storage tanks are to be retrofitted with anodes. The corresponding
specifications of the storage tank manufacturer must be respected.
2.3 Fitting principle
All fitting instructions and sketches only show the fitting principle in schematic
form. Install CORREX
correspond to what is shown on the schematic drawings or to what can be
unambiguously inferred from them. Do not install CORREX
anodes if this is not the case.
2.4 Technical changes
The shapes and forms of the individual components can be changed at any
time without prior notice, especially if such changes are owed to technical
improvement or if so requested by the customer.
26
® MP 2.3-900
MP 2.3-900 including the components shown
®
3 / "
4
/ "
1
4
MP 2.3-900 only if the actual fitting conditions
®
MP 2.3-900 is available with
®
MP 2.3-900
®