cecotec mambo 9090 Manuel D'instructions page 50

ENGLISH
This accessory works installed on top of the blades unit, this way it helps mixing food and is
not cut by the blades. It helps food mixing and removes lumps.
Install the butterfly on the blades unit by matching the shaft's centre with the butterfly's gap
and push it down.
Warning:
Do not operate the appliance unless the accessory is fixed in its place.
Do not operate it with speeds over 4.
Do not use the butterfly at the same time as the spatula.
Do not pour food in while it is operating with this accessory to avoid it from damaging or
getting blocked.
Basket
Fig. 19
The basket allows carrying out different functions:
Straining, juicer or sauces, dips etc. After blending, cooking or preparing sauce, assemble the
basket in the jar and pour the mixture.
Cooking soft foods, such as pasta or noodles.
Cooking side dishes such as rice or potatoes.
Steamer
The steamer includes 3 parts: a small steamer, a big one and the lid.
Close the steamer with its lid before using it.
Place the steamer on the jar, making sure it fits.
Warning:
Do not touch or get close to the steamer to avoid burns.
Do not cover the steamer's holes with any cloth or object. Steam may come out from the edge
or other parts causing risk of burns.
Allow steam to be released through the cover's middle hole and sides; this way, steam
circulation will be improved, allowing a more even cooking of foods.
4. BEFORE USE
Note: The product will produce a light smell when it is used for the first time and will disappear
after a few minutes. This is due to the manufacturing rests and does not affect to its operating.
Take the product out of the box and remove all packaging materials.
Make sure the product is in good conditions. If any sign of visible damage is observed, contact
immediately with our official Technical Support Service.
Place the appliance on a clean, stable and flat surface. Do not place it close to the edge, inside
built-in wardrobes or hanging brackets.
Clean the appliance before using it for the first time.
Connect it to a power supply and press the power switch to turn it on. The machine will beep
and the display will turn on.
50