Rockwell Automation Allen-Bradley PanelView 550 Instructions D'installation page 13

To connect DC power to the PV550/PV600 touch screen terminal:
1. Secure the DC power wires to the terminal block screws.
2. Secure the Earth Ground wire to the correct terminal block screw.
!
!
3. Apply 24V dc power to the terminal.
PV550 shown, PV600 similar
Power
Terminal
Block (fixed)
PanelView 550/600 Touch Screen Terminals
ATTENTION: Explosion Hazard - Do not connect or disconnect
equipment while circuit is live unless area is known to be non–
hazardous.
ATTENTION: Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may result in electrical
shock.
+
Earth Ground
DC Negative
DC Positive
11
41061-109-01(B)