ABB ACS55 Mode D'emploi page 9

EN
Installation and start-up steps
Read Safety instructions on page
Action
1 Check the delivery.
2 Ensure that the installation environment is suitable for ACS55.
3 Mount the unit.
4 Check applicability of the standard settings: Motor nominal frequency is 50 Hz; load is a pump or a fan; maximum output
frequency is 50 Hz. If the standard settings are not suitable, adjust the DIP switches.
5 Make sure the MOTOR I NOM potentiometer matches the rated current of the motor. It defines operation of the motor
thermal protection function.
6 Adjust the acceleration/deceleration time potentiometer ACC/DEC if necessary.
7 Connect the power supply cable and motor cables.
8 Connect the control wires.
9 Turn the power on. Green LED is illuminated. Note: Motor rotates if the start signal is active.
10 Set the speed reference and activate the start signal. The motor accelerates to the given speed reference.
7 before proceeding.
9
Pg.
7
10
12 -
13
14
16
16
17
18
20