Beta 1760/OHM Mode D'emploi page 64

9 Press EXIT for 2 seconds into the function of AC+DC. Test DC and AC TRUE Rms.
10 When the voltage of VAC>0.2V, the frequency of VAC can be read synchronously on the
11 RH auxiliary display
mV VoltaGe measurements
CAUTION:
Do not measure mV voltages if a motor on the circuit is being switched ON
or OFF. Large voltage surges may occur that can damage the meter.
1 Set the function switch to the mV position.
2 Press the mode button to indicate "dc" or "ac ", or in AC range press
eXit for two seconds and chose "AC+DC"
Insert the black test lead banana plug into the negative com jack. Insert
3
the red test lead banana plug into the positive V jack.
4 Touch the black test probe tip to the negative side of the circuit. Touch
the red test probe tip to the positive side of the circuit.
5 Read the mV voltage on the main display.
6 When mVac>2mV, the frequency of mVac can be read synchronously on
the RH auxiliary display
64