parkell MACH Serie Mode D'emploi page 3

10) To create a removable die model:
a. Leave the model in the plastic base former for now. Create individual dies by carefully cutting through interproximals with a single-edge razor
blade. Cut through the model to the top of the base former, without cutting through it.
b. Remove the cut model from the base former, grasp the model firmly, and snap apart the remaining uncut portion. This will form a rough edge
that will assure accurate re-assembly of the model in the base former. This is important for proper interproximal and occlusal contact, and for
proper contour of the restoration.
c. Trim dies if desired with a scalpel, and use any preferred restorative material to fashion a restoration. If desired, a light-cured restoration may be
post-cured along with the MACH/Blu-Mousse SuperFast working model in a thermostatically-controlled oven (e.g., toaster oven). Post-curing
enhances the physical properties of composites and may be accomplished by placing the restoration into an oven and raising the temperature
to about 120°C (250°F) and holding there for 10 minutes. DO NOT PLACE PLASTIC BASE FORMERS INTO THE OVEN—THEY WILL MELT!
d. Final occlusal adjustments and polish of the composite restoration(s) should be accomplished intra-orally AFTER it has been cemented with an
appropriate shade composite luting resin.
WARRANTY AND TERMS OF USE:
Parkell will replace defective material. This warranty is in lieu of all warranties of merchantability, fitness for purpose or other warranties, express or
implied. Parkell does not accept liability for any loss or damage, direct, consequential or otherwise, arising out of the use of or the inability to use the
product herein described. Before using, the user shall determine the suitability of the product for its intended use and the user assumes all risk and
liability whatsoever in connection herewith. For full Warranty and Terms of Use information, please see www.parkell.com.
Safety Data Sheets (SDS) are available at www.parkell.com.
Parkell's Quality System is certified to ISO 13485.
European Authorized Representative (Not a dealer/distributor):
Directa AB - P.O. Box 723, Finvids väg 8
SE-194 27 Upplands Väsby - Sweden
300 Executive Dr., Edgewood, NY 11717 USA
Toll-Free: 1-800-243-7446
Phone: (631) 249-1134
Fax: (631) 249-1242
E-Mail: info@parkell.com
Web: www.parkell.com
Emergency Phone (24 hrs.):
INFOTRAC
(North America) 1-800-535-5053
(International) 1-352-323-3500