Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FITTING INSTRUCTIONS FOR SP0032 SWINGARM-PROTECTORS
BMW ST 2006-
THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.
DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike.
T
(
)
HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY
FOR CLARITY OF INSTRUCTIONS ONLY
2
3
1
4
6
5
LEGEND
ITEM 1 = SPINDLE BAR (SB090 APPROX 237.5mm LONG) (x1)
ITEM 2 = M8 WASHER (19mm OUTSIDE DIAMETER) (x1).
ITEM 3 = M8 NYLOC NUT (x1).
ITEM 4 = R-H-S CRASH PROTECTOR (B0442 M8 (8mm INTERNAL DIAMETER)) (x1).
ITEM 5 = RIGHT-HAND SPACER (S0512, 70mm OUTSIDE DIAMETER ) (x1).
ITEM 6 = LEFT-HAND THREADED SPACER (S0511) (x1).
ITEM 7 = L-H-S CRASH PROTECTOR (B0442 M6 (6mm INTERNAL DIAMETER)) (x1).
Please note that in cases where kits are packed with rubber washers holding the components onto
the bolt – the rubber washers should be thrown away!
Publicité
Manuels Connexes pour R&G SP0032
Sommaire des Matières pour R&G SP0032
- Page 1 FITTING INSTRUCTIONS FOR SP0032 SWINGARM-PROTECTORS BMW ST 2006- THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike.
- Page 2 TOOLS REQUIRED SOCKET SET TO INCLUDE 13 AND 21mm SOCKETS SMALL AMOUNT OF SEMI-PERMANENT THREAD LOCK. FITTING INSTRUCTIONS PLACE THE SPINDLE BAR (ITEM 1) INTO THE THREADED SPACER (ITEM 6); PLEASE ENSURE THE THREADS ARE FULLY ENGAGED. IT IS A GOOD IDEA TO USE A SMALL AMOUNT OF SEMI-PERMANENT THREAD LOCK TO SECURE IN PLACE.
- Page 3 Instructions de montage SP0032 Protections bras oscillant BMW ST 2006- E KIT CONTIENT LES ARTICLES EXPOSES CI DESSOUS VERIFIER QUE TOUTES LES PIECES SOIENT PRESENTES AVANT DE PROCEDER AU MONTAGE A FAÇON DONT LE KIT EST EMBALLE NE CORRESPOND PAS FORCEMENT A LA FAÇON DE MONTER LES PIECES SUR LA MOTO ’...
- Page 4 Article 6 = Entretoise coté gauche (S0511) (x1). Article 7 = Protection coté gauche (B0442 M6 (6mm de diamètre interne)) (x1). Notez que si les kits sont emballés avec des rondelles en caoutchouc servant à tenir les composants, ces rondelles doivent être jetées. Outils requis ...