Télécharger Imprimer la page

TechniSat DIGITRADIO 600 Mode D'emploi page 13

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
4.3.4 Inserting the batteries
>
Push open the battery compartment cover on the back of the remote control.
>
Insert two "AAA" sized (Micro) batteries, 1.5 V, in the battery compartment and ensure the correct
polarity. A set of batteries is included in the scope of delivery.
>
Close the battery compartment lid carefully again until the lid engages.
Promptly change batteries that are losing power.
Always change both batteries at the same time and use the same type of batteries.
Leaking batteries can cause damage to the remote control.
If the device is not being used for a prolonged period, remove the batteries from the remote control.
Important information for disposal: batteries can contain poisonous substances which harm the
environment. Therefore, it is imperative to dispose of the batteries according to the legal provisions in
force. Never dispose of the batteries with normal domestic waste.
24
4.4 General device functions
Settings can be carried out both using the buttons on the device and with the remote control.
The description of the operation refers to the buttons on the remote control.
4.4.1 Switching on the device
>
You can use POWER on the device or On/Standby on the remote control to switch the device on or
back to standby.
After switching on for the first time, you can launch the set-up wizard (Section 14.7). Here you can set
the date and time either via DAB/FM, Internet or no update (manual). An attempt is then made to
establish a connection to a WLAN network. To do so, select the corresponding WLAN network and, if
required, enter the WLAN password with the remote control.
4.4.2 Operating the device with the remote control
With the infrared remote control you can operate the most important device functions from the comfort of
your armchair. When operating the device with the remote control, please take into account the following
points:
>
Point the remote control towards the front of the device.
>
Visual contact between the station and the receiver must be guaranteed.
>
If the range of the remote control reduces, replace the batteries new ones.
The maximum range is approximately 5 metres from the front of the device.
4.4.3 Adjusting the volume
>
Adjust the volume using the Volume +/- buttons on the remote control or VOLUME on the device. The
set volume is shown on the display.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
25

Publicité

loading

Ce manuel est également adapté pour:

Digitradio 630