Benning CM 11 Notice D'emploi page 14

TRUE RMS Digital Current Clamp Multimeter for
- DC/ AC voltage measurement
- DC/ AC current measurement
- resistance measurement
- continuity testing
Table of contents
1. User notes
2. Safety note
3. Scope of delivery
4. Unit description
5. General information
6. Ambient conditions
7. Electrical specifications
8. Measuring with the BENNING CM 11
9. Maintenance
10. Technical data of the measuring accessories
11. Environmental note
1. User notes
These operating instructions are intended for
- qualified electricians and
- electrotechnically trained persons.
The BENNING CM 11 is intended for making measurements in dry environment. It must not be
used in power circuits with a nominal voltage higher than CAT IV 300 V or CAT III 600 V (More
details in Section 6. "Ambient conditions").
The following symbols are used in these operating instructions and on the BENNING CM 11:
Application around and removal from HAZARDOUS LIVE conductors is permitted.

This symbol indicates an electrical hazard.

This symbol indicates sources of danger when using the BENNING CM 11 (see
documentation).

This symbol on the BENNING CM 11 indicates that the unit is protection insulated
(safety class II).
This symbol appears in the display for a discharged battery
This symbol indicates the continuity-testing application. The buzzer provides an
audible signal.
DC voltage or current

AC current or voltage
Earth (voltage to earth)
11/ 2018
Operating Manual
BENNING CM 11
BENNING CM 11

8