Publicité
Les langues disponibles
Les langues disponibles
Make 4 bore hole markings (10mm dia.); note
the position of opening A for the electrical
connection
Drill holes and blow out with a bellows
Check the distances between them
Hold the ceiling bracket on the ceiling and
hammer in the fastening anchor using a ham-
mer
Tighten the fastening using manufacturer
instructions
WARNING
Risk of injury from falling parts.
The ceiling bearing must be secured to the
fastening material, that must be suitable for
the corresponding ceiling condition.
Mounting must be performed by two people
All manuals and user guides at all-guides.com
A
CAUTION
Use protective equipment in line with tool
manufacturer's instructions.
Connect the plug from the ceiling tube with
plug on the ceiling arm
Carefully push protruding cable into the ceiling
tube
Perform this assembly step on an even surface:
3
metric
4
3
Insert the sliding piece 1 above into the ceiling
arm groove 2
Push the ceiling tube 3 and ceiling arm 2 to-
gether
Secure the sliding piece 1 by screwing in the
threaded stud 4 (up to the stop)
Loosen the threaded stud 4 again by a maxi-
mum of a ¼ turn and checking the rotating
function.
Place the end ring and ceiling cover on the
ceiling tube.
ENG
1
2
27
Publicité
