Frequently Asked Questions - Marmitek CONNECT 310 Guide Utilisateur

Battery
Remove the plastic strip from the battery compartment to activate the battery and use the
remote control.
USING THE SWITCHER
Switching between the connected HDMI sources
Automatically
When one of the HDMI sources is switched on, the Connect310 will automatically switch to
the correct input channel. If multiple HDMI sources are already switched on, the Connect310
will automatically switch to the last HDMI source activated.
Remark: Automatic switching has to be supported by the HDMI source.
With the selection button on the switcher
With the Select button at the top of the panel you can manually switch between the various
HDMI sources.
With the remote control
Point the remote control at the external infrared receiver of the Connect310 and press the
number that corresponds with the desired HDMI source.
The LED lighting on top of the panel shows which source is selected.

FREQUENTLY ASKED QUESTIONS

No (or poor) image and sound
If you experience poor or no image after connecting the HDMI switcher, try to recover the
problem by connecting the devices one at the time to your screen (TV, monitor or projector).
This way you can determine whether the problem lies with the HDMI sources, the HDMI
cables, the HDMI switcher or the screen. HDMI devices which are not tested and certified by
ATC (Authorized Test Centers) can cause image and sound problems.
• Check if the power adaptor of the Connect310 is connected and plugged into the mains.
• Only use High Speed HDMI® certified cables for the best picture and sound quality.
• Do not use HDMI cables that are longer than specified in the technical data.
• Both the HDMI source and your screen have to support HDMI fully.
• Check whether your HDMI sources, DVI device and screen support the copy protection
HDCP (High-bandwidth Digital Content Protection).
CONNECT 310™ 5