Frequently Asked Questions - Marmitek connect 410 Guide Utilisateur

USING THE SWITCHER
Switching between the connected HDMI sources
With the selection button on the switcher
With the Select button at the front of the panel you can manually switch between the various
HDMI sources.
With the remote control
Point the remote control at the Connect410 and press the number that corresponds with the
desired HDMI source.
The LED lighting at the front of the panel shows which source is selected.
Turning the switcher on or off
By pressing the Select button for 2 seconds the Connect410 will be switched on or off (or
use the remote control).

FREQUENTLY ASKED QUESTIONS

No (or poor) image and sound
If you experience poor or no image after connecting the HDMI switcher, try to recover the
problem by connecting the devices one at the time to your screen (TV, monitor or projector).
This way you can determine whether the problem lies with the HDMI sources, the HDMI
cables, the HDMI switcher or the screen.
• C heck if the power adaptor of the Connect410 is connected and plugged into the mains.
• Use HDMI certified cables of the highest quality (category 2 HDMI certified).
• Do not use HDMI cables that are longer than specified in the technical data.
• Both the HDMI source and your screen have to support HDMI fully.
• C heck whether your HDMI sources, DVI device and screen support the copy protection
HDCP (High-bandwidth Digital Content Protection).
Remote control does not work
• I nfrared signals have a maximum reach of approximately 10 metres. Try a shorter
distance.
• Replace the battery in the remote control, it could be empty.
Do you still have questions? Please check out www.marmitek.com for more information.
Connect 410™ 5