Frequently Asked Questions (Faqs); Notification; Declaration Of Conformity - Marmitek Connect 621 UHD 2.0 Guide Utilisateur

7 Frequently asked questions (FAQs)

No (or poor) image and sound
If you experience poor or no picture after connecting the HDMI switcher, please try to
identify the problem by connecting the devices to your screen (TV, monitor or projector)
one by one. This allows you to determine whether the problem is with the HDMI
sources, the HDMI cables, the HDMI switcher or the screen.
Make sure the power adapter is connected and plugged in.

For the best picture and sound quality, only use High Speed HDMI® certified

cables.
Do not use HDMI cables longer than those specified in the technical data.

Check the HDMI cables and/or connectors for damage.

Both the HDMI source and your screen should fully support HDMI.

Check that your HDMI sources and screen support HDCP 2.2 (High Bandwidth

Digital Content Protection) copy protection.
Incorrect 3D display
 Please check whether the HDMI source is set to display 3D and/or it is set to
automatic.
Both the HDMI source and your HD screen should support the same 3D formats.

Please check that 3D is displayed correctly by connecting the HDMI source

directly to the HD display with an HDMI cable.
Do you have any other questions that have not been resolved by the above
information? Please go to

8 Notification

8.1 Declaration of Conformity

Hereby, Marmitek BV declares that this Connect 621 UHD 2.0™ is in
compliance with the essential requirements and other relevant provisions of
the following Directives:
Directive 2014/30/EU of the European Parliament and of the Council of 26 February
2014 on the harmonisation of the laws of the Member States relating to
electromagnetic compatibility (recast)
Directive 2014/35/EU of the European Parliament and of the Council of 26 February
2014 on the harmonisation of the laws of the Member States relating to the making
available on the market of electrical equipment designed for use within certain voltage
limits.
Directive (EU) 2017/2102 of the European Parliament and of the Council of 15
November 2017 amending Directive 2011/65/EU on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
Commission Regulation (EU) 2019/1782 of 1 October 2019 laying down Ecodesign
requirements for external power supplies pursuant to Directive 2009/125/EC of the
European Parliament and of the Council and repealing Commission Regulation (EC)
No 278/2009.
You can read the Declaration of Conformity at
CONNECT 621 UHD 2.0™
www.marmitek.com
http://www.marmitek.com
9