Aligning The Camera - Medion S49014 Mode D'emploi

5.5.

Aligning the camera

In test mode, you can now test to find the optimal angle of
exposure and detection zone for the motion sensors.
NOTICE!
The use of the side motion sensors can
be helpful during the alignment process.
The side motion sensors can be activated/
deactivated via the corresponding menu.
Align the camera as follows:
 Fix the camera to a tree or a similar object at a height of
1-2m and point it in the desired direction.
 Then move slowly in front of the camera. Observe the
infrared LEDs while moving in front of the camera.
 If a blue LED lights up on the infrared LEDs then you
have been detected by the side motion sensors.
 If a green LED lights up on the infrared LEDs then you
have been detected by the front motion sensor.
NOTICE!
The motion display only lights up if the
OFF/TEST/ON switch has been set to
the TEST position and one of the motion
sensors has detected movement. The
LED display does not light up in normal
operation.
80 of 208