Unlocking Volume Control For A Single Device (Individual Volume Unlock); Unlocking All Volume Control (Restoring Default Setting); Clearing Custom Programming - One for All CURC4110 Guide De L'utilisateur

All manuals and user guides at all-guides.com
Enter 9 - 9 - 3 and then press any mode key once
2.
(e.g., TV). The LED will blink twice.
Now, when you press VOL +, VOL -, or MUTE,
3.
the volume of the selected device (e.g., TV) will
be controlled, regardless of the mode you have
selected.
Unlocking Volume Control For A Single Device
(Individual Volume Unlock)
1. After performing Global Volume Lock, press a
desired mode key where you want volume to be
unlocked (e.g., DVD) and controlled within its own
mode.
2. Press and and hold SET until the LED (red light)
blinks twice, then release SET.
3. Enter 9 - 9 - 3 and then press VOL - once. The LED
will blink four times.
4. If desired, repeat steps 1 through 3 for each device
that you want volume to be unlocked.
5. Now, after you select a device that has volume
unlocked (e.g., DVD), pressing VOL +, VOL -, or
MUTE will control the device's volume only in its
own mode.
Unlocking All Volume Control (Restoring
Default Setting)
NOTE: Performing these instructions will restore
independent volume control for all programmed
devices (e.g., TV volume control in TV mode, VCR
volume in VCR mode, etc.).
1. On the remote control, press and hold SET until the
LED (red light) blinks twice, then release SET.
2. Enter 9 - 9 - 3 and then press VOL + once. The LED
will blink four times.
3. Volume will again be independently controlled
according to its default states for all programmed
devices.

Clearing Custom Programming

This remote contains an Operational Feature Reset
program. If desired, you can use it to clear custom
programming (everything except your setup codes and
reassigned device keys), and reset them to original
factory settings. (See also "Restoring Factory Default
Settings", below.)
IMPORTANT: Executing this program will erase all your
custom settings for Volume Lock.
Press and hold SET until the LED (red light) blinks
1.
twice, then release SET.
Enter 9 - 8 - 0. The LED will blink twice. The remote
2.
control will return to normal operation.
8