Olympus PT-030 Mode D'emploi page 77

Maintenance of the TTL Connector Cap
After removing the TTL connector cap from the waterproof cap, be sure
to clean and grease the O-ring.
Use the waterproof cap maintenance adapter to remove the O-ring unit
from the waterproof cap.
Waterproof cap
1
Insert the adapter by aligning its pin with
the hole on the cap.
2
Turn the adapter counterclockwise to
remove the O-ring unit.
3
After removing the O-ring attached to the
O-ring unit, clean the O-ring groove and
apply silicon grease to the O-ring. Then,
re-attach the O-ring to the O-ring unit.
❈ Reverse the removal procedure to re-attach the O-ring unit to the
waterproof cap.
Waterproof cap
maintenance adapter
E-36
O-ring