Olympus PT-030 Mode D'emploi page 56

Removing the hot shoe cable cap
To perform TTL flash shooting when this case is used, connect the
hot shoe cable provided with the optional electronic flash case to the
connector on this case and the camera's hot shoe.
1
Turn the hot shoe cable connector cap
inside the case counterclockwise to
remove it.
2
Insert the connector of the hot shoe cable
into the case's connector and turn the
connector screws all the way clockwise to
connect them firmly.
3
Insert the hot shoe on the hot shoe cable
into the hot shoe on the camera.
4
When not using the hot shoe cable, attach
the hot shoe cable cap to the hot shoe cable
connector inside the case and turn the cap
all the way clockwise to attach it firmly.
CAUTION
: • Be sure to remove the camera from the case when
inserting the connector of the hot shoe cable into the
case's connector.
Lubricating the TTL Connector Thread
To facilitate attachment and removal of the TTL cable and TTL
connector, apply the silicone O-ring grease (provided with this Case),
to the threaded section.
For details, see the maintenance description on page E-35 of this
manual.
CAUTION
: • The SP-310 camera cannot be used in combination
with the separately available electronic flash case.
E-15