Power Fist 8088395 Guide De L'utilisateur page 8

Inserting drill bits/screwdriver bits
1. In order to insert a bit, grasp the back
section of the chuck and rotate the front
section of the chuck until the bit holder is
fitted.
2. Insert the tool as far as it will go into the
drill chuck opening.
3. Clamp in the screwdriver bits using the bit-
holder.
4. Select screwdriver bits appropriate to the
screw head in order to avoid damage to
screw heads.
5. Firmly tighten the chuck by hand. Ensure
the tool is firmly seated in the drill chuck.
Forward & Reversing Switch
Set rotation direction switch to R for
clockwise rotation, or to opposite side
(counter clockwise). When ON/OFF switch
is activated, rotation direction switch is
locked. Counter clockwise rotation is ideal
for loosening hardware like screws and nuts.
Switching On and Off
First set the rotation direction switch.
To switch on, press ON/OFF switch. Release
ON/OFF switch to switch off.
Drilling with lowest rotation speed for a
long time increases the risk of overheating
the motor. Allow a rest period after 15 mins of continuous use
Caution:
Before use check the direction of rotation. Only change rotational
direction when machine is not in operation.
Varying the Speed
Simply apply pressure onto the On-Off/Switch by squeezing it in, this
will increase the speed. Releasing the pressure on the On-Off/Switch will
decrease the speed.
Diagram 4
1. Front section of the
chuck
2. Back section of the
chuck
Diagram 5
1. Direction reversal
switch
2. On-off switch with
speed control 1 2