Power Fist 8088395 Guide De L'utilisateur page 7

Operation
1. Insert charged battery in handle and secure
with release button. The spring must snap
into place.
2. Separate the battery from the machine by
pressing the release button below the
machine handle.
Charge process
1. Carefully insert the battery pack into the
base of the device. Pay attention to the
correct direction and do not insert the battery
pack the wrong way.
2. Insert the output plug of the device into the
left side of the base.
3. Insert the power plug of the device into
the socket (up to 230V).
4. When the red indicator lights up, the
battery pack is being recharged. This
process lasts approximately 1-1.5 hours.
The red indicator lamp switches
automatically off after 1-1.5 hours again,
and green indicator lights up, this means
that the battery has been fully recharged.
Only then can the power plug be pulled out
of the socket. The battery pack can then be
taken out of the base and can be used
immediately.
Caution:
• The battery pack must be charged up before
the first use. The battery pack only reaches its full capacity after several
charges.
• Avoid repeated consecutive rapid charges of the battery. Do not recharge
after using only briefly, such as after only 15 mins of use.
• The battery pack and the power supply unit warm up during the charge
process. This is not a malfunction.
Diagram 2
1. Cordless drill
2. Battery pack
3. Release button
Diagram 3
1. Plug (AC)
2. AC adapter
3. Battery pack
4. Red indicator
5. Green indicator