Power Fist 8088395 Guide De L'utilisateur page 5

13. Look after your tools with care. Keep your tools ready for operation
(e.g. sharp) and clean in order to work well and safely. Follow the
maintenance regulations and the instructions for tool changes. Check
the plug and the cable regularly and, if these are damaged, have them
replaced by a recognized electrical specialist. Always keep handles
dry and free from oil and grease.
14. Unplug the tool when not in use, prior to maintenance and during the
tool change. (e.g. saw blade, drill bit and machine tools of all kinds.)
15. Do not leave any tools keys inserted. Before switching on, check that
keys and setting tools have been removed.
16. Avoid any unintentional operation/starting-up of the device. Do not
place your finger on the switch when carrying tools connected to the
power supply. Make sure that the switch has been switched off when
the device is connected to the power supply.
17. Extension cords. Outdoors, use only those extension cords that have
been approved for this purpose and are marked accordingly.
18. Always pay attention. Observe your work. Proceed sensibly. Do not
use the tool if you are lacking in concentration.
19. Check your device for damage. Before each use of the tool, carefully
check the problem-free and intended function of the protective
devices or of slightly damaged parts. Check whether the function of
moving parts is in order, whether they stick and whether parts are
damaged. All the parts must be correctly assembled and operating
properly to guarantee problem-free operation of the device. Damaged
protective devices and parts should be properly repaired or replaced
by a customer service workshop, unless otherwise indicated in the
operating instructions. Damaged switches must also be replaced at a
customer-service workshop. Never use tools with switches, which
cannot be switched on or off.
20. Repairs should be performed only by an electrical specialist. This
power tool complies with the relevant safety regulations. An electrical
specialist may carry out repairs.
21. For your own safety, use only accessories and additional devices
which are specified in the operating instructions or are recommended
by the tool manufacturer. The use of any tools or accessories other
than recommended in the operating instructions may entail a risk of
injury for you.