Install The Hood; Connect Ductwork - Best P195P Mode D'emploi

INSTALL THE HOOD

1. Cut a hole in the bottom of the cabinet.
See Fig.5
2. To install the hood, adjust the position of
the clasping side spring by turning the
screws, according to the thickness of the
cabinet to which it is going to be anchored.
See Fig.6
3. Insert the hood in the cabinet and lock into
position using the side spring.
4. Use the holes in the hood, secure it with (4)
mounting screws (B) - 3.2 x 16mm. See Fig.7
CLASPING SIDE
SPRING
A
A= min 7/16"- max 13/16"
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical codes.
•
120 VAC INPUT (FIG.8)
1. Secure the conduit to the wiring box through
a conduit connector.
2. Make electrical connections. Connect white
to white, black to black and green to green.
3. Install wiring box cover and secure it with (2)
screws 3,9 x 6 mm and (2) washers. Make sure
that wires are not pinched between cover
and box.
•
MAKE-UP AIR DAMPER CONNECTION (FIG.9)
1. Secure the conduit to the wiring box through
a conduit connector.
2. Make electrical connections. Connect black
to orange and black to white
Refer to Air Damper Models MD6T/MD8T
instruction.
3. Install wiring box cover and secure it with (2)
screws 3,9 x 6mm. and (2) washers. Make
sure that wires are not pinched between
cover and box.

CONNECT DUCTWORK

1. Use 8" round metal duct to connect the
duct connector on the hood to the ductwork
above.
2. Use duct tape to make all joints secure and
air tight.
MOUNTING SCREWS
(3.2x16mm)
2 Mounting screws on
each side (as shown)
Fig.6
- 6 -
10 ¼"
1"
X
X=
19-½" For Version P195P1M52
X=
26- " For Version P195PM70 Models
5/8
B
Dimension from bottom
edge of cabinet to center
line of screw/hole
(2) SCREWS
(3,9 x 6mm)
WIRING
BOX
COVER
120 VAC INPUT
(2) SCREWS
(3,9 x 6mm)
MAKE-UP AIR
DAMPER
CONNECTION
Fig.5
0,3"- 0,4"
Fig.7
WASHER
Fig.8
WASHER
WIRING
BOX
COVER
Fig.9