Install The Hood - Best IC34 Instructions

INSTALL THE HOOD

DUCTED AND NON-DUCTED INSTALLATION
1. Remove the electrical system box from
chimney frame by removing (2) 3.9 x 9.5
mm screws (Fig. 8).
2. Attach electrical system box to frame using
(2) 3.9 x 9.5 mm screws removed in Step
1 and (2) 3.9 x 9.5 mm screws and (2) lock
washers from hardware bag (Fig.9)
3. Fix the damper kit onto the hood using 4
screws (3.9x9.5mm) located in the
Damper Package (Fig.10).
4. Adjust the overall height using the chart
shown on page 10 of the support frame.
Loosen and re-tighten the 4 screws in the
height adjustment slots as necessary.
Insert 12 screws (3.9x9.5mm) located in
the Hardware Package (Fig.11) make
sure this a 4" min. overlap between the
upper and lower support legs.
MOUNTING
SCREWS
(6x60mm)
SUPPORT
FRAME
HEIGHT ADJUSTMENT
MOUNTING
SCREWS
3,9x9,5mm
FIG.11
SLOTS
MOUNTING SCREWS 3,9x9,5mm
MOUNTING SCREWS 3,9x9,5mm
MOUNTING SCREWS 3,9x9,5mm
- 11 -
MOUNTING SCREWS
3,9x9,5mm
FIG.8
FIG.9
FIG.10