Best P195P Mode D'emploi page 5

INSTALL DUCT CONNECTOR
1. Install the damper duct connector onto the
hood using mounting screws (3,9x9,5mm)
as shown in Fig.2
2. Remove the tape located on the damper.
See Fig.2.
INSTALL JUNCTION BOXES
1. In the area marked "120 VAC INPUT",
place a junction box on the top of the
hood. Run the wires through the hole
below and secure with (2) 3,9 x9,5 screws
and (2) washers. See Fig.3-4.
2. Repeat with the second junction box in
the area marked "Relay Contact
(30VRMS, MAX) Connection for Broan
Make-up Air Damper Models MD6T/
MD8T".
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where to install the duct.
2. A straight, short duct will allow the hood to
perform most efficiently.
3. Long duct, elbows, and transitions will
reduce the performance of the hood. Use
as few of them as possible.
4. Use duct tape to seal the joints between
ductwork sections.
Ducted configuration
Install a roof or wall cap. Connect 8" round metal
ductwork to cap and work back towards hood
location.
Non-Ducted configuration
nstall a decorative grill (not supplied by Best).
I
You may need to purchase a metal round-to-
rectangular transition depending on your
application.
MOUNTING SCREWS
(3,9 x 9,5mm)
"120 VAC INPUT"
P195PM70 Models
(shown in Fig.1a):
(shown in Fig.1b):
MAKE-UP
AIR DAMPER
MARKING
MARKED
DUCTED CONFIGURATION
HOOD
24" TO 30" ABOVE
COOKING SURFACE
NON-DUCTED CONFIGURATION
GRILL
(Not supplied)
AIR
DUCT
CONNECTOR
MOUNTING SCREWS
(3.9x9.5mm)
REMOVE THE TAPE
MAKE-UP
AIR DAMPER
MARKING
P195P1M52 Model
Fig.4
- 5 -
ROOF CAP
8" ROUND
DUCT
WALL
CAP
8" ROUND
ELBOW
8" ROUND
DUCT AND
ELBOW
At least
AIR
15"
HOOD
MOUNTING SCREWS
(3,9 x 9,5mm)
MARKED
"120 VAC INPUT"
Fig.1a
Fig.1b
Fig.2
Fig.3