Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE HOOD
CAUTION: At least two installers are
recommended because of the large size
and weight of this range hood.
1. Lift range hood into the ceiling opening.
2. Secure each support frame to the wooden
hood support frame using (6) 6 x 70 mm
lag bolts and washers provided. Fig. 7.
3. Adjust height of the telescoping support
frame to ensure a tight fit between the
hood and finished ceiling.
4. At the blower discharge collar, connect
ductwork that exhausts air to the outside
discharge. Fig. 8.
5. Duct tape all joints to ensure an air tight
seal.
2x4
WOODEN
FRAME
8" ROUND
DUCT
- 10 -
(6) LAG
BOLTS &
WASHERS
FIG. 7
FIG. 8
Publicité
Table des Matières
