Paper Replacement - Tool it PBT 550 Mode D'emploi

Translation of the original instructions
PRINTING OF TICKETS
1. Press «Print data» in the main menu
2. The data collected during the test is printed (battery test and/or start test and/or alternator charging system test).

PAPER REPLACEMENT

A. Open the transparent cover.
B. Place a new roll of paper in the compartment.
C. Place a small length of paper from the compartment and press the transparent cover to close.
DATA REVIEW
To read the data from the latest tests without printing a ticket, press «data review» in the main menu of the device.
Press OK to scroll through all the tests performed.
MAINTENANCE
Examples
Display switched off
Printing fault
Insufficient internal battery
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
PBT 550
"Check that the device is properly connected. The battery voltage is not high enough
to perform the test (<1.0 V).
Fully recharge the battery and try again."
"Paper jam: the paper is not inserted correctly.
Out of print paper: Insert paper."
Replace the batteries in the tester (3V - CR2032).
Analysis
EN
9