Programming Device Control - Universal Electronics COGECO ATLAS Guide D'utilisation

PROGRAMMING DEVICE CONTROL

The Cogeco Atlas DVR 5-Device Universal Remote Control
is preprogrammed to operate the Motorola digital cable
receiver provided by your cable system, an RCA TV, a
Toshiba DVD player, an RCA VCR (as an AUX device), and
a Pioneer audio receiver. To control devices other than the
default brands, perform the following steps; otherwise
skip this section:
NOTE: For TV/VCR Combo control, skip this section and perform
the instructions on page 12. Also refer to the "Device Table" on
page 8 to find out which devices can be programmed onto each
device key.
1.
2.
3.
4.
5.
Turn on a device and, if applicable, insert
video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down the codes
and device you wish to program before moving on to
step 2.
On the remote control, press a device key once
(i.e.., AUX, DVD, AUD, TV, or CBL); it will blink
once. Then press and hold SETUP until the
selected mode key blinks twice, then release
SETUP.
Use the Manufacturer's Codes (starting on
page 46) to locate the type of device and
brand name and then enter the first four-digit
code for your device. If performed correctly,
the selected mode key will blink twice.
NOTE: If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3 and try
entering the same code again.
Aim the remote control at the device and
press PWR once. The device should turn off.
If it does not, repeat steps 2 through 3, trying
each code for your brand until you find one
that works. If it still does not respond, try
searching for the code (see Searching For Your
Code on page 13).
NOTE: If the device does not have a POWER key,
( Play ) key.
press the
Repeat steps 1 through 4 for each device you
want the remote control to operate. For future
reference, write down each working device
code the boxes on the next page:
10