Programming Device Control - Universal Electronics ATLAS OCAP Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Atlas OCAP M1056.fm Page 10 Tuesday, March 24, 2009 4:45 PM

PROGRAMMING DEVICE CONTROL

The Atlas OCAP 5-Device Remote Control is
preprogrammed to operate the cable box (converter)
provided by your cable system, an RCA TV, a Toshiba
DVD player, an RCA VCR, and a Pioneer audio receiver.
To control devices other than the default brands,
perform the following steps; otherwise skip this section.
NOTES:
For control of a Combo device (for example, a
TV/VCR combo), skip this section and per-
form the instructions on "Setting Up a Combo
Unit" on page 11. Also refer to "Device Table"
on page 8 to find out which devices can be
programmed onto each device key.
If you have another brand of cable converter
or a satellite receiver you would like to control,
you'll need to unlock the cable ID Lock before
changing the converter code (see "Program-
ming Cable ID Lock" on page 17).
1.
Turn on a device and, if applicable, insert
video media, (e.g., cassette or disc).
NOTE:
Please read steps 2 through 4 completely
before proceeding. Highlight or write down
the codes and device you wish to program
before moving on to step 2.
2.
On the remote control, press a device key once
(i.e., VCR, DVD, AUD, TV, or CBL); it will blink
once. Then press and hold SETUP until the
selected mode key blinks twice.
3.
Use the "Manufacturer's Codes (Codes des
manufacturiers)" starting on page 54) to
locate the type of device and brand name and
then enter the first four-digit code for your
device. If performed correctly, the selected
mode key will blink twice.
NOTE:
If the selected mode key emits a long blink,
the entry is invalid. Repeat steps 2 through 3
and try entering the same code again.
4.
Aim the remote control at the device and
press PWR once. The device should turn off. If
it does not, repeat steps 2 through 3, trying
each code for your brand until you find one
that works. If it still does not respond, try
searching for the code (see "Searching for
Your Code" on page 12).
NOTE:
If the device does not have a PWR key, press
the(Play) key.
www.urcsupport.com/atlasocap
10

Publicité

Chapitres

Table des Matières
loading

Table des Matières