Troubleshooting - Universal Electronics COGECO ATLAS Guide D'utilisation

TROUBLESHOOTING

PROBLEM:
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM:
SOLUTION: Make sure you are aiming the remote control at
PROBLEM:
SOLUTION: Try all listed codes for the device brand being set
PROBLEM:
SOLUTION: Use the VCR codes for your brand. Some combo
PROBLEM:
SOLUTION: Follow instructions in Changing Volume Lock
PROBLEM:
SOLUTION: Re-program the CBL key for cable code 0476
PROBLEM:
SOLUTION: Try the "Search Method" again after clearing out
PROBLEM:
SOLUTION: For power on, these products require program-
Device key does not blink when you press a key.
alkaline batteries (see page 9).
Device key blinks when you press a key, but home
entertainment device does not respond.
your home entertainment device and that you
are within 15 feet of the device you are trying
to control.
The remote control does not control home
entertainment devices or commands are not
performing properly.
up. Make sure all devices can be operated with
an infrared remote control.
TV/VCR Combo does not respond properly.
units may require both a TV code and a VCR
code for full operation (see page 12).
No volume on a second TV.
(see page 20).
PLAY and STOP keys do not work on a Motorola
DCT-2000 digital cable receiver.
(see page 10, Programming Device Control).
Tried "Search Method" and still could not find a
working code.
the device key as follows: Press and hold SETUP
until device key blinks twice, then release. Next
enter 9 - 9 - 2. Then press and release the device
key to be cleared twice.
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.
22