Removing Monitor/Player Unit; Removing The Unit - Kenwood DNX Série Manuel D'installation

Removing Monitor/Player Unit

Removing the Hard Rubber
Frame (escutcheon)
1. Engage the catch pins on the removal tool
5 and remove the two locks on the lower
level.
Lower the frame and pull it forward as
shown in the figure.
Accessory 5
⁄
• The frame can be removed from the top side in
the same manner.
2. When the lower level is removed, remove
the upper two locations.
Catch
Lock

Removing the Unit

1. Remove the hard rubber frame by referring
to the removal procedure in the section
<Removing the Hard Rubber Frame>.
2. Insert the two removal tools 5 deeply into
the slots on each side, as shown.
3. Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
⁄
• Be careful to avoid injury from the catch pins on
the removal tool.
4. Pull the unit all the way out with your
hands, being careful not to drop it.
Accessory 5
11
English