For All Models - Eskimo QuIckflIp 2 Instructions De Montage

More ice fisherman choose Eskimo than any other brand
Quickflip 2 (69167), Quickflip
™
2. Insert (6) 27.76" vertical assembly poles (68186) into the previ-
ously assembled horizontal pole/plastic corner assemblies by
lining up snap button with the snap button holes in plastic corner
pieces. Snap into place. Poles will have a snug fit and may
shave some interior plastic off. This is by design for a good fit.
SEE fIGuRE 6.
3. Take the (3) hinge upright poles from each hinge assembly and
insert them into the (3) assembled top cross brace poles (large
loop poles). Push the snap buttons inward and allow cross brace
poles to go over hinge poles and slide them to their shortest
height (transport mode). SEE fIGuRE 7.
4. Unfold the skin and locate the Eskimo logo near the zippered
door, which is the front of shelter. With the front of shelter skin
laying face down on the ground, in front of shelter, locate the (3)
fabric sleeves sewn to the bottom seam on front side of shelter.
Slide the 67.52" horizontal assembly pole (68191) through the
long fabric sleeve. Insert the horizontal assembly pole into (2)
plastic corner pieces by lining up snap button with snap button
holes in plastic corner pieces. Snap into place. Pole will have
a snug fit and may shave some interior plastic off. This is by
design for a good fit. SEE fIGuRE 8.
5. Insert (2) 29.64" vertical assembly poles (68187) through the
short fabric sleeves and into the previously assembled horizon-
tal pole/plastic corner assembly by lining up snap button with
the snap button holes in plastic corner pieces. Snap into place.
Poles will have a snug fit and may shave some interior plastic
off. This is by design for a good fit. SEE fIGuRE 8.
6. Take the J-hinge poles from each hinge assembly and insert
them into the assembled bottom cross brace pole assembled in
step 5. Push snap buttons inward and allow cross brace to snap
into place. SEE fIGuRE 8.
7. Drape the rest of the shelter skin over the shelter sled, seats
adn poles and position it the best you can.

fOR All mODElS

1. Unzip door and move to the inside of shelter and extend the (3) top cross
brace poles and snap into place. Place back spreader pole with stud, both
roof spreader poles and both door spreader poles into position by snapping
C-clip over cross brace poles. For back spreader pole, simply place end
with stud into pre-drilled hole in back lip of sled. Attach all Velcro loops to
cross brace poles. SEE fIGuRES 9 & 10.
2. Move to outside of shelter. Find the center of the edge trim and line it up
with the center of sled lip on back side of shelter. Pull down on the skin
evenly over the sled lip until it is snug.
NOTE: When pulling skin tight, DO NOT lift the bottom cross brace
pole off the ground. Bottom cross brace pole should always contact
the ground.
Temporarily press the edge trim over the skin and sled lip. Using a rubber
mallet may be helpful to press over the sled lip.
1-800-345-6007
3 (69168) & Express
™ ™
GetEskimo.com
2 (69802)
snap button
bottom
brace pole
assembly
fIGuRE 8
snap button snapped
in place
fIGuRE 9
front J-leg
pole
fabric sleeve
Page 11
®