Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
More ice fisherman choose Eskimo than any other brand
Quickflip
2 (69167), Quickflip
™
fOR QuICKflIP 2 & ExPRESS 2
1. Insert (3) 57.21" horizontal assembly poles (68188) into (6) plastic
corner pieces (68175) by lining up snap button with snap button
holes in plastic corner pieces. Snap into place. Pole will have a
snug fit and may shave some interior plastic off. This is by design
for a good fit. SEE fIGuRE 6.
2. Insert (6) 24" vertical assembly poles (68184) into the previously
assembled horizontal pole/plastic corner assemblies by lining up
snap button with the snap button holes in plastic corner pieces.
Snap into place. Poles will have a snug fit and may shave some
interior plastic off. This is by design for a good fit. SEE fIGuRE
6.
3. Take the (3) hinge upright poles from each hinge assembly and
insert them into the (3) assembled top cross brace poles (large
loop poles). Push the snap buttons inward and allow cross brace
poles to go over hinge poles and slide them to their shortest height
(transport mode). SEE fIGuRE 7.
4. Unfold the skin and locate the Eskimo logo near the zippered door,
which is the front of shelter. With the front of shelter skin laying
face down on the ground, in front of shelter, locate the (3) fabric
sleeves sewn to the bottom seam on front side of shelter. Slide the
54.52" horizontal assembly pole (68189) through the long fabric
sleeve. Insert the horizontal assembly pole into (2) plastic corner
pieces by lining up snap button with snap button holes in plastic
corner pieces. Snap into place. Pole will have a snug fit and may
shave some interior plastic off. This is by design for a good fit. SEE
fIGuRE 8.
5. Insert (2) 25.14" vertical assembly poles (68185) through the
short fabric sleeves and into the previously assembled horizon-
tal pole/plastic corner assembly by lining up snap button with
the snap button holes in plastic corner pieces. Snap into place.
Poles will have a snug fit and may shave some interior plastic
off. This is by design for a good fit. SEE fIGuRE 8.
6. Take the J-hinge poles from each hinge assembly and insert
them into the assembled bottom cross brace pole assembled in
step 5. Push snap buttons inward and allow cross brace to snap
into place. SEE fIGuRE 8.
7. Drape the rest of the shelter skin over the shelter sled, seats
and poles and position it the best you can.
8. Assemble the two sets of door spreader poles (69356 & 69357)
by sliding the male half into the female half and snapping in
place with snap button. SEE fIGuRE 9.
fOR QuICKflIP 3 ONly
1. Insert (3) 70.02" horizontal assembly poles (68190) into (6)
plastic corner pieces (68175) by lining up snap button with snap
button holes in plastic corner pieces. Snap into place. Pole will
have a snug fit and may shave some interior plastic off. This is
by design for a good fit. SEE fIGuRE 6.
Page 10
3 (69168) & Express
™
™
GetEskimo.com
2 (69802)
horizontal pole
fIGuRE 6
fIGuRE 7
assembly
plastic corner
vertical pole
assembly
top brace poles
snap button
upright poles
1-800-345-6007
®
Publicité
Table des Matières
