Horizon Global 76929 Instructions D'installation page 8

3. Remove bumper beam: Using 14mm socket, remove (6) M10 factory bolts attaching
bumper beam to vehicle. Return bumper beam to vehicle owner, save for reinstall.
4. Install hitch: b) Using 11/16" Socket, detach brackets from hitch before installation.
Save 7/16" carriage bolts, 7/16 conical washer, and 7/16 nut for reinstall. Apply blue
thread locker to all bolts. Using the reverse pull wire method ⑤, attach the 1/2"
carriage bolt ① and spacer ② to pull wire and into position, both sides. Loosely
install bracket to vehicle frame rail using 1/2" conical washer ③, and nut ④, both
sides.
© 2022 Horizon Global™ Corp. - Printed in Mexico
4. Install hitch: a) Remove plug from access hole shown. Using die grinder, enlarge
hole to fit 1/2" carriage bolt ① and spacer ② through hole, both sides of vehicle.
4. Install hitch: c) Raise hitch into position and loosely install (6) M10 factory bolts, (3)
per side. Reinstall 7/16" carriage bolts, 7/16" conical washers and 7/16" nuts
removed in step 4b, both sides.
5. Tighten 7/16" fasteners with torque wrench to 50 Ft.-Lb. (68 N*M)
6. Tighten M10 factory bolts with torque wrench to 42 Ft.-Lb. (57 N*M)
7. Tighten 1/2" fasteners with torque wrench to 75 Ft.-Lb. (102 N*M)
Sheet 8 of 27 76929NP 09-13-22 Rev. A