General
•Aurilis assumes no liability for injury to persons damage to movable or immovable property loss of profit or any other loss or damage
caused by the improper mounting or use of the carrier, inducing but not limited %o mounting or use in conflict with the assembly
instructions, moraine instructions or any other instructions given. in writing or verbally. by Aurilis or a Aurilis dealer.
•The carrier and its parts must net be modified in any way.
•Consult your Aurilis dealer if you have any questions about the operation, use and limits of the canner. Read ell of the instructions and
Warranty information carefully before mounting and using the carrier.'
•The Safety instructions should be retained for future reference and to ensure that any other users of the bike carrier are familiar with
its content.
Fitting
•Check the assembly instructions to make Sure that all the necessary parts of the carrier are present
•Read and follow the assembly instructions and the recommendation list carefully, if the list is included. Then fit the unit in the correct
sequence by following points 1. 2, 3 and so on.
•Do not attempt to fit the carrier in any other way than the way shown in the mounting instructions.
•In the case of the roof mounted carrier, if no special fitting positions are given in the assembly instructions, ensure that there is a
minimum distance of 700mm between the front and rear racks. B5 The load may not exceed the load carrier's width, and it should be
spread evenly across the load Carrier and with the lowest possible center of gravity
Loading
•The maximum load for the carrier as appealed in the assembly instructions , must not be exceeded. In addition the maximum load
recommended for the vehicle itself always takes priority over the load specified in the assembly instructions. It is always the lower
recommended maximum load that applies and that must not be exceeded
•The maximum load for the carrier, as specified in the assembly instructions, applies to vehicles in motion as well as parked vehicles.
•The load must be carefully secured. Elastic burgees must not be used
•Check and do not exceed the maximum weight per bike specified in the mourning instructions. C5 The carrier is constructed to carry
only standard bike frames. Tandem bikes must not be transported on the carrier. Always cheek and do not exceed the maximum bike
frame size (diameter) specified in the mounting instructions.
•In the case of bikes with carbon frames or forks, always consult the bike manufacturer or dealer to check if you are allowed to use the
carrier.
•Aurilis assumes no Viability for any damage to carbon frames or forks incurred during mounting and/or use of the carrier.
•All easily removable parts of the tares must be removed before transportation including but not limited to Child seats, baskets, locks (if
not permanently mounted) and air pumps. These parts can become detached during transportation because of increased air resistance
and vibration and can constitute a danger to other road users.
Driving characteristics and regulations
•This product is not approved for and must not be used during off-road driving. Adapt your speed to the prevailing road conditions and
the load being carried. Check the load fastenings regularly
•The vehicle driver is solely responsible for ensuring that the earner is in perfect condition and that the carrier and load are securely
fastened (even if fitted by a third person).
•Every time the carrier is used, check that the carrier is securely fitted after driving a short distance (50km) and then at regular intervals.
If you notice any unusual noise, movement of the load and/or carrier different behaviour of the vehicle or other unusual conditions,
stop and check that the carrier and load are secured correctly, and in accordance with the mounting instructions.
•The vehicle's total length and/or height may increase when a carrier is mounted. The bikes themselves may increase the vehicle's total
width and height. Take special care when reversing and/or entering garages or ferries etc.
•Replace any damaged or worn parts of the carrier immediately. During transportation, all levers, bolts and/or nuts must be tightened
in accordance with the mounting instructions.
•Carriers fitted with a lock must always be in the locked position. The keys must be removed and kept inside the vehicle during tran-
sport.
•Be aware that the vehicle's driving characteristics and braking behaviour (including in curves) might change and that the vehicle might
become vulnerable to side winds when the carrier is fitted.'
•The vehicle's speed must always be adjusted to the load being carried and the current driving conditions, such as the road type, road
quality, wind conditions, traffic intensity and applicable speed limits, but must under no circumstances exceed 130 km/h. Applicable
speed limits and other traffic regulations must always be observed.
•Be aware that wind, noise maybe generated during transport and may vary depending on the vehicle and load.
•For reasons of fuel economy and environmental impact as well as the safety of other road users, the carrier must be removed from the
vehicle when not in use.
Maintenance
•Clean the carrier regularly using warm water or car shampoo, especially when using or after using the carrier in coastal areas (the
effect of salt water) or during periods when salt is applied to the roads (winter time).
•Screws, nuts and locks (if fitted) should be lubricated at regular intervals.
•Remove the carrier before using an automatic car wash.
•When the carrier is removed from the vehicle, it must be stored in a dry storage area. All the components of the carrier must be stored
safely. Remember to clean and maintain the carrier in accordance with the instructions.
•If you lose part(s) of the carrier or part(s) of the carrier wear out, only use genuine Aurilis spare parts as replacements. Spare parts can
be purchased from your dealer or manufacturer.
•To ensure that you receive the spare parts quickly and to avoid time-consuming queries, please provide the. relevant product details
and the serial number when placing an order or making an inquiry.
•In order to ensure that you are able to replace lost or defective keys as quickly as possible, note down the lock and key number which
can be found on your key and lock.