User Maintenance - Andis BTF-3 Instructions D'utilisation Et D'entretien

BLADES
When trimming is complete, slide ON/OFF switch to OFF position and remove
the attachment comb (if being used). Lightly brush out blades with the blade
cleaning brush provided. For best results put a drop of Andis Clipper Oil on the
blade when necessary. Motor bearings are permanently lubricated–do not
attempt to oil. Blades should be handled carefully and never bumped or used to
cut dirty or abrasive material. Do not use while bathing or in the shower, as
damage to battery and product may occur.

USER MAINTENANCE

Cleaning and user maintenance shall not be made
by children without supervision.
The internal mechanism of your trimmer has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station.
CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES
(Trimmer shown in figures may vary from the one that you have)
The blades should be oiled before, during, and after each use. If your trimmer
blades leave streaks or slow down, it's a sure sign that the blades need oil. The
trimmer should be held in the position shown in Figure G to prevent oil from
getting into the motor. Place a few drops of Andis Clipper Oil on the front and
side of the cutter blades (Figure H). Wipe excess oil off the blades with a soft dry
cloth. Spray lubricants contain insufficient oil for good lubrication, but are an
excellent trimmer coolant. Always replace broken or nicked blades to prevent
injury. You can clean the excess hair from your blades by using a small brush or
old toothbrush. To clean the blades we suggest immersing the blades only into a
shallow pan of Andis Clipper Oil, while the trimmer is running. Any excess hair
and dirt that has accumulated between the blades should come out. After
cleaning, turn your trimmer off, dry the blades with a soft, dry cloth and start
clipping or trimming again.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your trimmer does not develop a
"memory effect" like a nickel-metal hydride (NiMH), or nickel cadmium (NiCd)
battery. You can return the clipper to the charger at any time for a full charge,
or even use the battery before a charge cycle is complete. Like most
rechargeable batteries, lithium-ion batteries perform best when used
frequently.
2. For maximum battery life, store the clipper in a partially discharged condition
7