Andis BTF-3 Instructions D'utilisation Et D'entretien page 6

REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug
until it releases from power adapter.
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on
input plug (Figure B).
2. Gently push input plug into power adapter until it snaps into place.
CHARGING TRIMMER
This battery charger is intended for use with Andis model BTF3 lithium-ion
battery with a rated capacity of 3.7V
adapter from the carton. Plug the adapter into a 230V AC outlet, or according to
your local power standards. Note that the trimmer ON/OFF switch must be in
the OFF position for the battery to charge. Plug the adapter cord directly into
the trimmer (Figure C). The green light on the trimmer will turn on. The trimmer
has not been charged at the factory. Please charge the trimmer for 2 hours
before the first use for maximum performance. You can keep the trimmer
plugged into the adapter when not in use. The adapter will maintain the battery
at full charge and the green light will stay on. However, we recommend that the
adapter be unplugged if the trimmer won't be used for seven or more days.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord is plugged firmly into trimmer. Twist the
adapter connector slightly to insure good electrical connection. If failure to
charge still exists, return trimmer to Andis or an Andis authorized service
station for examination and repair or replacement.
USE WITH ADAPTER CORD
If the trimmer powers OFF in the middle of a trimming job, the power cord can
be attached to continue use in corded operation. When the trimmer is running
with the power cord attached, the green light will remain off, even if the battery
is partially or fully discharged. The trimmer will not charge while in use with the
cord attached.
USING ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
Trimmer may come with 6 attachment combs: 1/2", 3/8", 1/4", 7 day, 5 day and
a 3 day for even closer trimming (Figure D). To use, slide front of attachment
comb over the teeth of the blade. Snap comb down over back of blade
(Figures E & F).
6
2.8 Wh. Remove the trimmer and AC