User Maintenance - Andis CTA-1 Mode D'emploi

lengths of cut. Different blade angles in relation to the skin, thickness and
texture of the hair will vary the cutting length.
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From coarse to
fine cuts, all that is needed is an easy change of the adjustment lever with
your thumb.

USER MAINTENANCE

The internal mechanism of your clipper has been permanently lubricated at
the factory. Other than the recommended maintenance described in this
manual, no other maintenance should be performed, except by Andis
Company or an Andis authorized service station. To contact Andis
directly, please call our Customer Support Team at 1-800-558-9441 or
email us at support@andisco.com.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade
heat often, especially on close cutting blades. If blades are too hot, dip the
blades only into Andis Blade Care Plus or apply Andis Cool Care Plus and
then Andis Clipper Oil.
CARE AND SERVICING OF YOUR ANDIS CLIPPER
BLADES
The blades should be oiled before, during, and after each use. If your
clipper blades leave streaks or slow down, it's a sure sign the blades need
oil. Place a few drops of Andis Clipper Oil on the front and side of the
cutter blades (Figure D). Wipe excess oil off the blades with a soft, dry
cloth. Spray lubricants contain insufficient oil for good lubrication, but are
an excellent clipper coolant. Always replace broken or nicked blades to
prevent injury. You can clean the excess hair from your blades by using a
small brush or an old toothbrush. To clean the blades we suggest
immersing the blades only into a shallow pan of Andis Blade Care Plus
while the clipper is running. Any excess hair and dirt that has accumulated
between the blades should come out. After cleaning, turn your clipper off,
dry the blades with a soft dry cloth, and start clipping again.
If after cleaning, blades do not cut properly, a few, fine pieces of hair may
be trapped between the upper and lower blades. Remove the blade set
from the clipper (see "Mounting and Dismounting the Blade Set"). Hold
7