User Maintenance - Andis AGC2 Instructions D'utilisation Et D'entretien

move switch button by pressing down on the lock mechanism and moving to
the #1 or #2 position. To stop, press down on the lock mechanism and move
switch button back to original position. After using your Andis clipper,
rewrap cord, and store in a safe place.
REMOVING BLADE SET
To remove blade set, first make sure your clipper motor is switched "OFF".
Push blade release mechanism under blade hinge (Diagram B). While
holding down the blade release mechanism, push down on blade, then
gently pull the blade forward (Diagram C), and slide it off the blade hinge.
If your blade hinge should snap closed and is flush with the clipper, use a
small standard screwdriver to pry the tongue of the hinge out (Diagram D).
NOTE: Hair may accumulate in the front cavity of the housing under the
blade. If this happens, you can clean out the hair by brushing out the cavity
with a small brush or an old toothbrush while the blade is off the clipper
(See Diagram E for location of cavity being referenced).
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge
of the clipper (Diagram F) and with the clipper turned "ON", push the blade
towards the clipper to lock into position.

USER MAINTENANCE

The internal mechanism of your motor clipper has been permanently
lubricated by the factory. Other than the recommended maintenance
described in this manual, no other maintenance should be performed,
except by Andis Company, or an Andis authorized service station. To find an
Andis authorized service station near you log on to andis.com or contact
our customer service department: 1-800-558-9441 (U.S.).
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat
often, especially on close cutting blades. If blades are too hot, dip the
blades only into Andis Blade Care Plus or apply Andis Cool Care Plus and
then Andis Clipper Oil. If you have a detachable blade unit, you can change
your blade in order to maintain a comfortable temperature; using multiple
blades of the same size is popular among groomers.
4