Dry Vacuum Operation - EWT CS 3 Mode D'emploi

DRY – VACUUM OPERATION
1
6
DRY VACUUMING
BEFORE YOU START
WARNING!
Be sure to read, understand, and apply Section 1, entitled
'Safety Warnings'.
Reminder: DO NOT vacuum hazardous substances.
The use of an incorrect dust bag will void the warranty.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, verify that the dust filter is clean and dry. Place
the dust filter over the basket filter and centre it.
Push down until the mounting ring of the dust filter is positioned against the ribs of the top section
(Fig. 2).
3. Verify that the dust filter completely covers the filter basket. Also verify that all edges of the dust filter
are secure under the mounting ring (Fig. 3).
4. Verify that the dust bag is installed to the inside of the tank (Fig. 4).
5. Place the top section back on the container, and secure it in place using the clasps (Fig. 5).
6. Insert the larger end of the flexible hose into the front inlet on the tank, and lock in place. Push the
required attachment onto the free end of the hose or extension (Fig. 6).
7. Plug the power cord into the outlet (Fig. 7).
8. Turn the motor on by flipping the switch to the "I" position (Fig. 8).
9. Once you have completed vacuuming, flip the switch to the "O" position and unplug the power cord
from the power outlet.
2 3
7
8
4
35
5