General Assembly Instructions - EWT CS 3 Mode D'emploi

GENERAL ASSEMBLY INSTRUCTIONS

1
5b
10
GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the clasps (Fig. 2).
3. Lift the top section off the container (Fig. 3).
4. Remove the contents from inside the container (Fig. 4).
5. Turn the container upside down, and insert the four castors. Verify that they are mounted correctly.
Do not over-tighten (Fig. 5).
6. Insert the handle into the slots on the power head and pressure into place (Fig. 6).
7. For dry vacuuming, install the supplied dust filter and dust bag (Fig. 7, Fig 8).
8. For wet vacuuming, install the supplied foam filter (Fig. 9).
9. Place the top section back on the container (Fig. 10).
10. Align the top section with the clasps, and snap into place by applying pressure until clasps latch into
place (Fig. 10).
11. Insert the large end of the hose into the front inlet of the container, and lock it by pushing and
twisting (Fig.11).
12. Choose the desired accessories and push onto the suction tube (Fig. 12).
2
6
11
12
3
4
7 8
34
5a
9