Cleaning The Tool; Environmental Protection - Worx WG546E Mode D'emploi

OPERATION
INTENDED USE:
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
ASSEMBLY AND OPERATION
ACTION
Assembling & disassembling the Blower
Tube
Installing & Removing the Battery Pack
10
NOTE: Depress the battery release
button to release battery pack from
your tool. After recharging, insert the
battery pack into tool's battery port. A
simple push and slight pressure will be
sufficient.
Checking the battery condition
BEFORE USING YOUR CORDLESS
BLOWER
Your battery pack is UNCHARGED, you
must charge before use.
Charging the battery
More details can be found in charger's
manual
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because of an electrical failure and
hazard will occur.
Starting & Stopping
WARNING! The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
Cordless Li-Ion Blower/Sweeper
Waste electrical products
must not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your local authorities or retailer
for recycling advice.
xINR18/65-y: Cylindrical
lithium Ion battery cells with
max diameter of 18mm and max
height of 65mm; "x" represents
a number cells serial connected,
blank if 1; "-y" represents a
number of cells paralleled
connected, blank if 1.
Blowing
USER TIPS
- Hold the blow tube approximately 20cm
above the ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other
suitable eye protection, long pants,
and shoes.
Adjusting the Blowing Speed

CLEANING THE TOOL

FIGURE
Clean the tool regularly.
See Fig.
A&B
WARNING! Keep your product dry.
Under no circumstances spray with
water.
- To clean the tool, use only mild soap and a
See Fig.
damp cloth.
C&D
- Do not use any type of detergent, cleaner
or solvent which may contain chemicals
that could seriously damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
ENVIRONMENTAL
PROTECTION
See Fig. E
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling
advice.
See Fig. F
See Fig. G
See Fig. G
EN