Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. INTENDED USE
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
5. OPERATION
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Assembling & disassembling the blower
tube
Installing & removing the battery pack
NOTE: Press the battery release button
to release battery pack from your tool.
After recharging, insert the battery pack
into tool's battery port. A simple push
and slight pressure will be sufficient.
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
Fig. E2 only applies for the battery pack
with battery indicator light.
10
WARNING! The charger and
battery pack are specially
designed to work together, so do
not attempt to use any other devices.
Never insert or allow metallic objects into
your charger or battery pack connections
because of an electrical failure and
hazard will occur.
OPERATION
Starting & Stopping
WARNING! The tool runs for a few
seconds after it has been switched
off.
Let the motor come to a complete
standstill before setting the tool down.
20V Cordless Blower
Adjusting the blowing speed with 2-speed
switch
USER TIPS
- Hold the blow tube approximately 8"
above the ground when operating the
tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front of
you.
FIGURE
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
See Fig.
Caution!
A, B
-
Do not blow hard objects such as
nails, bolts, or rocks.
-
Do not operate the blower near
bystanders or pets.
See Fig.
-
Use extra care when cleaning
C, D
debris from stairs or other tight
areas.
-
Wear safety goggles or other
suitable eye protection, long
pants, and shoes.
To store your cordless blower
NOTE: You can store your cordless
blower by hanging it on the wall with your
own wall hanging support at the back of
the blower.
See Fig.
E1, E2, E3
6. CLEANING THE TOOL
Clean the tool regularly.
Warning! Keep your product dry. Under no
circumstances spray with water.
- To clean the tool, use only mild soap and a damp
cloth.
- Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
- Self lubricating bearings are used in your
See Fig. F
product, therefore lubrication is not required.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
The recommended ambient temperature range for
the charging system during charging is 0
See Fig. G
See Fig. H
o
o
C-45
C.
o
o
C-40
C.
EN
Publicité
Table des Matières
