R&G SP0057BK Guide Rapide page 2

Please note that in cases where kits are packed with rubber washers holding the components onto the
Left-hand side (as you sit on bike)

Fit the shorter counter sunk bolt through the crash protector so head sits in counter-sink.

Place the crash protector on to the smaller mounting block.

Place special nut on exposed end of bolt so tapered face goes into recess of the mounting
block.

Tighten bolt until tapered portion of nut just contacts in the recessed face of the mounting
block.

Place this assembly into the left hand side of the rear wheel spindle.

Tighten the bolt so crash protector is held in position firmly (do not over tighten).

Regularly check to ensure crash protector remains tight.
Right-hand side (as you sit on bike)

Fit the longer counter sunk bolt through the crash protector so head sits in counter-sink.

Place the crash protector on to the larger mounting block.

Place special nut on exposed end of bolt so tapered face goes into recess of the mounting
block.

Tighten bolt until tapered portion of nut just contacts in the recessed face of the mounting
block.

Place this assembly into the left hand side of the rear wheel spindle.

Tighten the bolt so crash protector is held in position firmly (do not over tighten).

Regularly check to ensure crash protector remains tight.
RIGHT HAND SIDE
bolt – the rubber washers should be thrown away!
TOOLS REQUIRED

4mm metric Allen key.